578 Product Finder M MF UNC UNF G Rp, R, Rc NPT, NPTF BSW Pg EG (STI) SELF-LOCK Tr, Tr-F Rd Glatt Smooth GT, TD Zubehör Accessories PoCoSys Kalibrieren Calibration MJ UNJC, UNJF Gewinde-Grenzlehren (Dorne und Ringe) · Thread Gauges Go/No-Go (Plug and Ring Gauges) MJ P 60° DIN ISO 5855 Lehrenmaße nach DIN ISO 1502 Gauge dimensions acc. DIN ISO 1502 Toleranz · Tolerance 4H 4h 4h Beschichtung · Coating ø d 1 mm P mm G-GR-LD G-GUT-LR G-AUS-LR M 3 x 0,5 L0100110.1229 L0200510.1229 L0300510.1229 4 x 0,7 L0100110.1231 L0200510.1231 L0300510.1231 5 x 0,8 L0100110.1232 L0200510.1232 L0300510.1232 6 x 1 L0100110.1233 L0200510.1233 L0300510.1233 8 x 1 L0100110.1235 L0200510.1235 L0300510.1235 10 x 1,25 L0100110.1236 L0200510.1236 L0300510.1236 Toleranzangaben nach DIN ISO 5855 Bei der Toleranzangabe des Innengewindes von 4H5H (bis MJ 5x0,8 von 4H6H) und des Außengewindes von 4h6h steht als erstes die Toleranzklasse des Flankendurchmessers, gefolgt von der Toleranzklasse des Kerndurchmessers (Innengewinde) oder des Außendurchmessers (Außengewinde). Am Innengewinde beträgt die Flankendurchmesser-Toleranz 4H und die Kerndurchmesser-Toleranz 5H (bzw. 6H). Die Kerndurchmesser-Toleranz wird durch den Gewindelehrdorn nicht erfasst und deshalb nicht angegeben. Am Außengewinde beträgt die Flankendurchmesser-Toleranz 4h und die Außendurchmesser-Toleranz 6h. Die Außendurchmesser-Toleranz wird durch den Gewindelehrring nicht erfasst und deshalb nicht angegeben. Tolerance specifications according to DIN ISO 5855 The tolerance specification of 4H5H (up to MJ 5x0.8 of 4H6H) for the internal thread and 4h6h for the external thread indicates in the first digits the tolerance class of the pitch diameter, followed by the tolerance class of the minor diameter (internal thread) or the major diameter (external thread). The tolerance of the pitch diameter of the internal thread is 4H and the tolerance of the minor diameter is 5H (respectively 6H). The tolerance of the minor diameter is not checked by the thread plug gauge and therefore not indicated. The tolerance of the pitch diameter of the external thread is 4h and the tolerance of the major diameter is 6h. The tolerance of the major diameter is not checked by the thread ring gauge and therefore not indicated.
RkJQdWJsaXNoZXIy NjMxNTU=